Upstand to tile
The vertical joint on the raised edge of the tray.
Shower tray resealing renews the silicone on the upstand, the wall joint, and the front lip. Book it when the bead has split and the tray is not cracked. A waste leaking under the tray is identified and is not quoted as a bead. Send a photo on the quote form, or WhatsApp the same details.
Who it is for
Households with water on the floor at the front of the tray. People who can see a gap between the upstand and the tile. Anyone told “just silicone it” when the waste may be the leak. Stone-resin, acrylic, and ceramic trays are in scope if the body of the tray is sound.
Variants
The vertical joint on the raised edge of the tray.
The edge you step over, where a split bead dumps water on the floor.
The extra joint where a tray sits on a riser and the panel meets the tray.
Water that appears under the tray with a sound bead is the waste or the trap, not this reseal.
Scope
How it is done
Floor water at the lip is often the bead. Water only under the tray, with a dry lip, is often the waste.
Old silicone comes off the acrylic or resin without scoring the tray.
The agreed edges are resealed in sanitary silicone.
Keep water off the new bead for 24 hours. That is the minimum cure before a shower, bath, or basin is used again.
Symptoms
The lip bead has split or was never bonded to the tray.
You can see tile or daylight at the joint. Water tracks behind the tray lip.
Look at the waste before paying for silicone.
No bead closes a crack through the tray body.
Quote
The job is quoted. These are the factors, not a menu of fixed prices.
Three walls and a front lip is the usual tray. A riser panel joint adds length.
Acrylic needs a slower cut than a ceramic tray edge.
If the visit becomes a leak check because the waste is at fault, you are not sold a bead that cannot work.
After the visit
Do not stand a bottle on the fresh lip bead. Keep the tray dry for 24 hours. After that, the waste still needs its own seal if that was the leak we flagged.
An upstand joint lasts when the tray does not flex away from the wall and the silicone was bonded to a clean edge. A tray that creaks underfoot will open the front lip again.
DIY
The front lip is where thick DIY beads sit and then peel. If water is under the tray rather than over the lip, another tube will not reach the waste.
Questions
Yes. Upstands, front lips, and tray-to-tile joints on sound acrylic, stone-resin, and ceramic trays. A cracked tray is not resealed as if it were a bead.
Water over the front lip, or a visible gap at the upstand, fits the bead. Water only underneath, especially when the bead looks intact, fits the waste. Say which one you see on the quote form.
Yes. Say so on the form and it is quoted as one shower visit. This page is the tray and upstand. The screen joints are covered under shower resealing and can be booked together.
Twenty-four hours after the bead is finished.
Related work
Areas we cover
Send the photo and the postcode on the form, or WhatsApp the same details. Water stays off the new bead for 24 hours.
Name the room and the joint. If a ceiling below is stained, say when the water appears.